ICC-ES Editorially Revised Acceptance Criteria
Acceptance criteria and evaluation guidelines are used as the basis for evaluating a product, and establishing conditions of acceptance in an evaluation report, when the product type is not clearly addressed in existing codes and code-related documents.
- (AC04) Sandwich Panels
- (AC05) Sandwich Panel Adhesives
- (AC10) Quality Documentation
- (AC11) Cementitious Exterior Wall Coatings
- (AC12) Foam Plastic Insulation
- (AC13) Joist Hangers and Similar Devices
- (AC16) Plastic Glazed Skylights
- (AC17) Glass Glazed Unit Skylights and Sloped Glass Glazing
- (AC23) Spray-applied and Intumescent Mastic Coating Fire-protection Materials
- (AC29) Cold, Liquid-applied, Below-grade, Exterior Dampproofing and Waterproofing Materials
- (AC32) Concrete with Synthetic Fibers
- (AC39) Walking Decks
- (AC43) Steel Deck Roof and Floor Systems
- (AC46) Cold-Formed Steel Framing Members
- (AC48) Roof Underlayment for Use in Severe Climate Areas
- (AC51) Precast Stone Veneer
- (AC65) Concrete and Clay Tile Fasteners
- (AC71) Foam Plastic Sheathing Panels Used as Weather-resistive Barriers
- (AC77) Smoke-containment Systems Used with Fire-resistive Elevator Hoistway Doors and Frames
- (AC85) Test Reports
- (AC86) Cold-Formed Steel Framing Members – Interior Nonload-Bearing Wall Assemblies
- (AC90) Fiber Cement Siding Used as Exterior Wall Siding
- (AC92) Polymer-based and Polymer-modified Exterior and Interior Wall Cladding
- (EG100) Air-conditioning Equipment Pads
- (AC101) Grease Duct Enclosure Assemblies
- (AC106) Predrilled Fasteners (Screw Anchors) in Masonry
- (AC109) Thermoplastic Composite Lumber Products
- (AC115) Waterproof Membranes for Flooring and Shower Lining
- (AC124) Rim Board Products
- (AC129) Steel Moment Frame Connection Systems
- (AC132) Attic Vents
- (AC133) Mechanical Connectors for Steel Bar Reinforcement
- (AC148) Flexible Flashing Materials
- (AC152) Adhesive Attachment of Concrete or Clay Roofing Tiles
- (AC154) Cyclic Racking Shear Tests for Metal-sheathed Shear Walls with Steel Framing
- (AC155) Hold-Downs (Tie-Downs) Attached to Wood Members
- (AC160) Nonasphaltic Fiberglass-based Roof Underlayment
- (AC165) Asphalt-Coated Glass-Fiber Mat Roof Underlayment
- (AC170) Shear Reinforcement Devices in Structural Concrete
- (AC174) Deck Board Span Ratings and Guardrail Systems (Guards and Handrails)
- (AC175) Raised Floor Systems over Concealed Spaces
- (AC180) Clay and Concrete Roof Tiles
- (AC181) Rigid Cellular Polyurethane Panels Used as Exterior and Interior Wall Cladding
- (AC184) Attachment Devices for Recessed Lighting Fixtures (Luminaires) in Suspended Ceiling Systems
- (AC187) Polyester Loose-fill and Blanket Insulations
- (AC188) Roof Underlayments
- (AC205) Dynamic Seismic Retrofit Systems for Masonry Structures
- (AC207) Polypropylene Roof Underlayments
- (AC209) Acceptance Criteria For Trowel-, Spray- Or Roller-applied Water-resistive Coatings Used as Weather-resistive Barriers over Exterior Cementitious Wall Coverings
- (AC219) Exterior Insulation and Finish Systems
- (AC230) Shear Wall Assemblies Consisting of Wood Structural Panel Sheathing Attached to Cold-Formed Steel Framing with Pneumatic- or Gas-Power-Driven Pin Fasteners
- (AC235) EIFS Clad Drainage Wall Assemblies
- (AC243) Composite Foundation Drainage Systems
- (AC252) CPVC Systems of Piping, Fittings And Solvent Cement Used in Chemical Waste Systems
- (AC257) Corrosion-resistant Fasteners
- (AC259) Pneumatic- or Gas-power-driven Pin Fasteners Used to Attach Gypsum Panels to Cold-formed Steel Framing
- (AC261) Connectors Used with Cold-formed Steel Structural Members
- (AC269) Racking Shear Evaluation of Proprietary Sheathing Materials Used as Braced Wall Panels
- (AC282) Thin Shell, Cementitious-coated, Cold-formed Steel Stud Wall Panels
- (AC283) Metal Hinge Plate Connectors for Wood Trusses
- (AC292) Plastic Footing Form Systems
- (AC294) Shutters for Protection Against Wind-borne Debris
- (AC298) Internal Epoxy Barrier Pipe Coating Material
- (AC316) Shrinkage Compensating Devices
- (AC322) Prefabricated, Cold-Formed, Steel Lateral-Force-Resisting Vertical Assemblies
- (AC337) Window Wells
- (AC340) Patio Covers
- (AC344) Riveted Connections of Cold-formed Steel Structural Members Using Self-piercing Rivets
- (AC353) Stay-in-Place, Foam Plastic Insulating Concrete Form (ICF) Systems for Solid Concrete Walls
- (AC362) Adhesive for Masonry Construction
- (AC366) Polypropylene Siding
- (AC387) Metal Webs for Parallel Chord Wood Trusses
